GREAT PLAINS 7323DH, Predelivery Manual

Page: 15 / 70

Series II Disk Harrow Table of Contents Index Assembly 11
2021-06-10 Table of Contents Index 556-235Q
Hitch and Lever Link Assembly

The hitch to frame assembly will be the same on
both the narrow and wide models. Narrow shown.
Refer to Figure 8
18. Install hitch assembly to front of center frame with the 1
1

4
” x 8” Gr. 8 hex bolts provided. Be sure and install
1
1

4
” machine washers as needed on both sides, to insure a tight fit (be sure and have same amount on both
sides of hitch). Secure with the 1
1

4
” top lock nuts. Bolts need to be tightened down securely on the ball joints but
do not torque as hitch needs to pivot freely.
19. Remove the tongue jack from its storage location at rear of hitch and install it on the jack stub at the front of the
hitch frame to support the front side of hitch.
20. Connect the bottom of leveling turnbuckle to rear of hitch with 1
1

4
” x 6” Gr. 5 special thread bolt , and
1” nylon lock nut, (do not torque bolt), connect the top of the turnbuckle to the middle hole of leveler assembly
with the 1
1

4
” x 11” hinge pin ,
1

2
” x 2
5

8
” Gr. 8 special thread hex bolt and
1

2
” top lock nut.
21. Attach spring hose loop to front of hitch assembly with
1

2
” x 1
1

2
” hex bolts ,
1

2
” flat washers,
1

2
” lock
washers and
1

2
” nuts.
22. Bolts may be tightened to specs, See “ Torque Values Chart ” on page 19.
11 12
13
14
15 16
17
18 19
20 21
12
11
13
17
18
15
U
D
F
B
L
R
12
14
16
19
20
21
Figure 8
Hitch to Frame Assembly
43448