8
Hardware for Step 7:
4x #6 Barrel Nuts
I
I
G
4x #5 Connecting Bolts 80mmL
#5
#5
#5
#5
#6
#6
STEP 7:
Take the remaining side rail (G) and orientate with the wooden slat support rail closest to the lower edge.
With one person supporting the side rail, connect with the bed end at the lower position as shown using
the dowels. Insert 1x barrel nut (#6) into the large hole on the side rail, then insert 1x LONGER 80mm
connecting bolt (#5) from the outside leg and tighten with your fingers.
Repeat with the other end of the side rail.
Now attach 1x shorter front guard rails (I) to the bed end above the front side rail using the 1x barrel nut (#6)
and 1x longer connecting bolt (#5). When in place, connect the ladder panel (K or L) with the front guard rail
using the dowels. This will support the guard rail.
Repeat with 2nd front guard rail and 2nd ladder panel.
Now go back and FULLY TIGHTEN the 8x bolts used in steps 6 & 7 using the allen key provided.
#6
2x
K
L
