6
STEP 3: It is suggested this step is completed on the floor.
Using the dowels, assemble the bed end by locating one of the prepared headboards
(F) and headboard rails (E) into the LH assembled leg.
Please note the IMPORTANT orientation guidance below on panel E.
Once both panels are in place locate the RH assembled leg into place.
Repeat this for the second bed end.
IMPORTANT: The orientation of panel E is important
and if assembled upside down, it will cause alignment issues
later on in the assembly.
Note the dowels on ends of panel E are not centralised.
Please ensure that the 2x dowels are closest to the
bottom edge of the panel/rail.
E
STEP 4:
Secure panels F & E to the assembled legs using 6x 30mm SHORTER wood screws
(#8).
Note: Hardware #9 is very similar in size (35mm), but will damage the panels if used.
Please check before using.
Repeat step with second bed end.
#8
Hardware for Step 4:
12x #8 Screws 30mmL
F
E
F
#8
#8
#8
#8
#8
#8
