TP-183P User Manual
Installation 2-2
2.2 Stand Installation
It is recommended to assemble the stand by at least 2 people to prevent damages from
dropping components onto the ground.
Installation
procedure:
1. Fasten 2 sets of side stand and Stand Base by supplied screws.
A
H
2. Fasten with Stand Beam by supplied screws.
B
【
Figure 2-3
】
【
Figure 2-2
】
A
H
B
A
H
2.3 Plotter
Setup
Proceed as following:
Step 1
Place the plotter onto the stand and fasten them up.
(Note: the wire and Control board must be located at the same side)
F
The wire
to connect the power board
of Paper Take-Up System
and plotter
Control board
for Paper Take-Up System
F
【
Figure 2-4
】
