24
USER MANUAL
GRAVITY Xfusion
EN REV.V01 - 2020
27.
The lines are collected in S-folds so that it gives about 2 - 3 line bundles. Again, care should be taken that
the excess of the line loops behind the rubber are kept as small and tight together as possible. From the last
line groups to the main riser 15 cm of the lines should be left out / over when closing the cover
28.
The cover sheet of the inner container should be closed with the rubber at the end of the slot anda final short
line loop. The Xfusion is now ready for installation into the harness. The connection of the Xfusion to the
harness is installed according to the recommendations of the harness manufacturer (harness manual). The
riser of the Xfusion should be connected to the suspension point of the harness.
PLEASE NOTE_
For the connection of the handle there are two loops on the outside face of the inner
container.
