GB - 21
2. Connect the other end of the positive (+)
jumper cable to the positive (+) terminal of
the booster battery.
3. Connect the negative (–) jumper cable to
the negative (–) terminal of the booster
battery.
4. Connect the other end of the negative (–)
jumper cable to the engine of the unit with
the discharged battery.
NOTE:
If engine will not start, the unit or the
battery may need service.
5. Start engine.
6. After engine starts, leave jumper cables
connected for one to two minutes.
7. Disconnect jumper cables in reverse
order of installation.
8. Operate unit as normal to charge battery.
STEERING LEVER
ADJUSTMENTS
Adjusting Steering Levers to Match
(Figure 22)
NOTE:
Each steering lever (item 1) can be
positioned further forward or further backward.
1. Loosen mounting hardware (item 2).
2. Position steering levers (item 1) to match.
3. Tighten mounting hardware (item 2).
Adjusting Height of Steering Levers
(Figure 22)
There is a low and a high position for steering
levers (item 1). Remove mounting hardware
(item 2) and place steering levers (item 1) in
the low or high position. Tighten mounting
hardware (item 2).
PTO BELT REPLACEMENT
Remove (Figure 23)
1. Lower mower deck to the ground.
2. Remove belt covers (item 7) from mower
deck.
3. Hook a puller into idler hole (item 4) and
pull idler arm (item 6) towards outside of
unit until tension is removed from PTO
belt (item 3).
4. Remove PTO belt (item 3) from left
mower deck pulley.
WARNING:
Make sure cables are
clear of any moving engine parts
before starting engine.
CAUTION:
Use care when releasing
idler spring tension. Keep body parts
well away from idler when performing
this operation.
1
OE0046
Figure 22
2
1. Steering Lever
2. Mounting
Hardware
Low
Position
High
Position
Figure 23
7
OE0080
3
1. Idler Spring
2. Electric Clutch
3. PTO Belt
4. Idler Hole
5. Idler Pulley
6. Idler Arm
7. Belt Cover
1
2
4
6
5
