ULTRAMAT AC/DC EQ
7
Nixx
LiFe
LiPo
Lilon
Pb
Lithium batteries need to balance for more safety, if lithium batteries are charged
without balance board, the balancing of lithium batteries is not performed.
◎ BATTERY TYPE SELECTION
◎ BATTERY CONNECTION
Connect charge cable to 4mm output banana sockets on charger with attention to polarity,
red +, black –. If battery is not connected to charger correctly, the error message is ap-
peared
- No battery : When a battery is not connected to the charger’s output
- Open circuit : When a battery becomes disconnected during an operation
- Reverse polarity : When a battery is connected to the output in reverse
When the power supplier is connected to the charger the below screen is displayed and
the Setup screen is displayed after about 1 second
Press BATT TYPE button twice to select Battery type
※
The programming setup is applied differently when you press START/STOP button less
than 1 Sec and longer than 1 Sec
Press ENTER button then battery type blinks and press ENTER button again then
other value blinks. If you leave it for more than 3 sec without operating, the blinking is
stopped. Press and hold ENTER button to start charge or discharge.
Pofile
LiPo
Ultramat AD EQ
Graupner/SJ 1.00
Pofile
Nixx
Pofile
LiPo
Pofile
LiFe
Pofile
Lilo
Pofile
Pb
2S
6S
3S
3S
3S
12V
[01]
800
[01]
3000
[01]
3000
[01]
3000
[01]
3000
[01]
pack
CAUTION
Summary of Contents for ULTRAMAT AC/DC EQ
Page 20: ......
