GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Keine Haftung für Druckfehler. Technische Änderungen vorbehalten! Liability for printing errors excluded. We reserve the right to introduce modifications. Sous réserve de
modifications! Nous ne sommes pas responsables d’éventuelles erreurs d’impression!
#0059017
06/2008
15
end of the flexible aerial to a washer (part 24).
•
Fit the second washer on the M2.5 screw (part 25),
followed by one loop of the external aerial; fit this
assembly through the hole in the hull from the outside.
Now slip the washer with the flexible aerial soldered to
it on the end of the screw projecting inside the hull,
followed by the nut (part 26); tighten the parts
together to clamp the aerial. TIP: apply plenty of UHU
hart round the nut on the inside of the hull; this will
make the hole watertight as well as preventing the nut
working loose.
•
Connect the water-cooling coil to the silicone hoses. If
the factory-fitted hoses are not long enough, they can
be extended with the additional piece of silicone
tubing (part 27). A 32 mm length of aluminium tube is
supplied to act as hose connector (part 28).
IMPORTANT: rotate the coil of tubing on the motor to
a position where the projecting tube ends do not foul
the underside of the hatch cover.
•
Fix the drive battery in the hull using the remaining 80
mm length of Velcro tape (part 21). The battery should
be positioned in the hull in such a way that the fully-
equipped boat balances at a point approximately at
the forward end of the hatch cover. You will probably
need to adjust the position of the battery to obtain the
correct trim; the use of Velcro tape makes this an
easy task.
•
Apply the decals to the boat as shown in the kit box
illustrations. It is best to cut out the decals accurately,
leaving no margin, and apply each one separately.
TIP
: the decal for the tip of the bow is slightly
oversized; carefully trim off the excess at the edge of
the hull using a sharp modelling knife.
