14 / 33
Using Rechargeable Batteries Option
The back side of the mz-10c is equipped with a charging port for recharging
NiMH batteries
(No. S8359)
.
WARNING
Follow all safety instructions included with the batteries!
Charging Port Polarity
Only use original
Graupner
charging cables. Charging cables sold by other
manufacturers often have different polarities and can permanently damage
your batteries or equipment.
Note
The charging socket comes with a protection switch that protects against
polarity reversal. Original
Graupner
automatic chargers recognize the
battery charge. In order to prevent damage to the protection switch and to
the other components, charging current should never exceed 1 A.
Transmitter Functions
Transmitter Status Indications
The transmitter is pre-set at the factory to
GENERAL
Region Setting and
Mode 2
.
After switching on the transmitter the central LED on top blinks red and an
acoustic signal is emitted. Refer to the chart below for status indication.
Central status LED
Buzzer
Description
Solid on (factory setting)
short power on melody
Transmitter switched on
Solid on
No melody
Country setting: GENERAL
blinks each second
No melody
Region setting: FRANCE*
on or blinks
1 beep each second
Receiver battery voltage too low
blinks 3 times
3 short beeps consecutively
Bad signal power from receiver
blinks 4 times
4 short beeps consecutively
Bad receiver back channel signal power (yellow BIND LED
lights)
blinks 5 times
5 short beeps consecutively
Transmitter battery or battery voltage too low
*Disregard the FRANCE mode setting; this is for backwards compatibility
purposes only.
Do not attempt to change the country or region settings!
