32 / 36
S1036.77_jh_V1_de
Firmware update
The programs and files which are also required for updating the
transmitter combined into one software package can be down-
loaded from
www.graupner.de
.
Download this software package from the Internet, and unpack
it on your computer. All other information can be found in inter-
net in the same page where the software package is available.
Firmware updates of the transmitter can be performed in two
ways.
Update through memory card
Update through USB port
Note
Please note that compatible firmware is required for reliable
communication between the HoTT components. The programs
and files that are required to update are therefore combined into
a single file.
The current firmware version can be found on the Internet at
www.graupner.de.
Only operate your transmitter using the current software version.
these information can also be found at: www.graupner.de =>
Service & Support => Update and revision history for GRAUPNER
HoTT components.
Before each update, check the transmitter battery charge or
charge it as a precaution, and save all model memories so that
they can be restored if necessary.
Do not disconnect the link to the computer during an update!
Make sure that the link between the transmitter and computer is
operational.
After each update, check to make sure that the models function
correctly.
Update through memory card
Download the actual software package from the Internet, and
unpack it on your computer. Insert the supplied mini SD Card in
the card slot of your PC and copy the required firmware file from
the unpacked software package into the directory "Firmware“
on the memory card. Then, remove the memory card from the
PC and insert it in the card slot of the transmitter.
Switch on the
transmitter and the RF module off.
Go to the submenu "FIRMWARE UPDATE" in the menu "Hidden
mode" and proceed as described in the "Hidden mode" section.
