14 / 16
3974.2_MP_V1
Setting the Kingpad
A co-ordination between the Graupner / Kingpad mc Edition and
the Kingpad Central Module must take place so that the perfect
function is guaranteed. Proceed as follows:
Make sure there is a connection between the remote control
and the receiver.
Kingpad assignation in the transmitter:
In the transmitter call up the menu "Control setting" and assign the
Kingpad like a normal switch to the desired channel. On the model
side, this selected control channel must be connected by means of
the enclosed patch cable from the receiver output to the "Kingpad"
input on the Kingbus Central Module. Driving and steering channel
must continue to remain connected to the central module as well!
Press the white Prog button on the KBCM for more than 2 seconds
until the yellow LED flashes in a second rhythm
Push the upper left button (sidelights) on the light module. As
confirmation for a detected key, the Prog-LED on the KBCM goes
off and remains off when pressed!
Release the button. The Prog-LED flashes again and the next key
can be read.
Now press the individual buttons of the light module one after
the other; followed by the buttons of the switch module. Always
starting from top left to right and then bottom left to right!
After the 24th key (F3) the Kingbus Central Module automati-
cally exits the programming mode and returns to normal mode.
The Kingpads are now set and they can be used