14 / 24
S1032_mz-8P_V1.1sh
• If a copter has already been bound to the transmitter and this
combination is to be put back into operation, then for safety rea-
sons, first the transmitter and then the copter must be put into
operation. The corresponding connection is then automatically
established.
Range test
By triggering the integrated range test by simultaneously pressing
the transmitter's "SPEED" and "SNAP" buttons, the transmit power
of the
mz-8P HoTT
transmitter is reduced so that a functional test
can already be performed at a distance of 5 to about 10 m. After the
90 second range test, the transmitter switches back to full output,
and the signal tone stops. Alternatively, however, the range test can
be ended manually at any time by pressing the "SPEED" and "SNAP"
keys again.
Perform the range test for the
Graupner
-HoTT system according to
the following instructions. It is useful to have an assistant to help you
with the range test.
1. Switch on the remote control and then connect a battery to the
copter or switch on its power supply. Wait until both devices sig-
nal a correct connection. Now the motors or propellers should
run controllably.
2. With the motor OFF function activated, place the model on level
ground (pavement, short lawn or earth) so that it is at least 15
cm above the ground. It may therefore be necessary to place a
support underneath the model during the test.
3. Hold the transmitter at hip level at a slight distance from your
body.
4. Deactivate the motor OFF function and start the range test by
simultaneously pressing the "SPEED" and "SNAP" keys.
5. The red status LED on the transmitter will start to blink quickly
and a signal tone is emitted twice each two seconds.
6. Move away from the model within these 90 seconds while mov-
ing the sticks. Make sure, however, that the model does not stand
out in an uncontrolled manner. If you detect an interruption in
the link within a range of about 5 - 10 m at any time, attempt to
reproduce it.
7. Move further away from the model until it does not respond per-
fectly.
8. At this location, wait for the remainder of the test period with the
still operable model. The model should still react to control com-
mands once the range test is finished. If this is not 100 % the
case, do not use the system and contact our Service department.
9. After the 90 second range test, the transmitter switches back to
full output, and the signal tone stops. By simultaneously pressing