18
19
Flying
Now we are ready to fly!
Binding
Checklist before starting
Each time before starting the helicopter, check if all its parts are properly installed and undamaged.
The helicopter must be held so that the rotors can freely rotate since they can cause injury.
First turn on the transmitter and then the helicopter.
First turn off the helicopter, and then you can turn off the transmitter.
If this sequence is not followed (that is, the receiver remains turned on and the transmitter is
turned off), the receiver can be controlled by other transmitters, interference, etc. The motor
may start.
Each time before use, check for proper function, range and mode. From an appropriate distance
from the model, check if all the functions work.
Warning:
Never use the model in a hall with air
blowers since this would be like operating the helicopter in a strong wind which could blow the model
out of range or cause it to lose control.
Flight time:
When the battery is fully charged, the helicopter will fly for approximately 3-5 minutes
if there is no wind.
If the model starts or rises slowly, charge the flight battery.
Switch on the transmitter.
Switch on the transmitter to check if transmitter in auto-rotation phase.
Helicopters Do not move when you turn until the Flybarlesssystem has initialized
(Swash plate shrugs 3 times) (page 18)
Pitch stick to minimum and switch to normal flight phase.
Then pitch stick slowly slide it forward until the helicopter takes off.
The trim control should never be operated. If the model after reinitializing always
still drifts in one direction, needs the servo center position in the receiver menu S1, S2,
and S3-center against the drift to be adjusted.
Provide helicopter on level ground, check again if there are no people, animals or other
Obstacles in the vicinity.
Summary of Contents for HEIM 3D 100
Page 11: ...11 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 Description of the transmitter ...
Page 17: ...17 Notes ...
Page 21: ...21 Notes ...
