GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
No liability for printing errors. Technical changes reserved
28/3/2012 ID no. 0062914
Page 14
2. Slide the wings into the fuselage, toward the rear, and fasten them to the
fuselage with the M5 plastic screw included with the kit.
Receiver assembly
1. Now insert all cables into the receiver as described in the instructions for your
transmitter or receiver.
Attention!
Make sure that the cables coming out of the wings are routed in the cable shaft on
the impeller and not pressed onto the wings. The wing fits into the fuselage
opening without using force. If this is not the case, check the position of the
cables.
Attention!
With the use of a GR-12 HoTT receiver, the second elevator servo is plugged into
channel 6 and it is either set to channel 8 through the servo output menu in the
transmitter or channel 6 is mapped to channel 8 through the receiver telemetry
function. This way, any existing mixers in the transmitter can work again with two
elevator servos.
