GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors. Id.-Nr. 0062439 5/2011
-
3
-
Installing the receiving system
The illustration shows the HoTT receiver (not included) installed above the rudder
servo using the Velcro tape (8) and (9). Route the receiver aerials through the fuse-
lage opening above the speed controller. We recommend the following receiver
channel assignment: connect the speed controller to receiver socket I, the left aileron
servo to socket II, the elevator servo to socket III, the rudder servo to socket IV, the
right-hand aileron servo to socket V. Coil up the servo leads next to the receiver, so
that they cannot obstruct the servo output arms when they move. Connect the 100
mm servo extension leads (10) to sockets II and V.
The receiving system is switched on by plugging in the LiPo battery (11), i.e. by
connecting the G3.5 plugs and sockets as shown above. Bind the receiver to the
transmitter using the procedure outlined in the manual supplied with your RC system.
Check the direction of motor rotation: if the propeller spins clockwise when viewed
from the tail, disconnect the push-button (bottom of picture) from the speed controller.
Installing the wing
Slip the servo leads through the appropriate channel in the fuselage (1) as shown in
the picture; this is easier if you use a pair of tweezers or small pliers.
