GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
No liability for printing errors. We reserve the right to introduce modifications.
#00596367 12
/2009
7
Decal sheet (2089.G)
The purpose of the decal sheet is to finish off the Bismarck in the scheme used at the time the vessel
was sunk. If the decals are not applied, the ship appears in its form as commissioned. Of course,
various modifications were carried out between these two times, but it is not possible to incorporate
these into the model.
The decals are applied as follows: first cut out the individual panels, leaving the transfer film on the
decal. Remove the backing paper on the adhesive face, then apply the decal to the model.
TIP:
we
recommend that you wet the surface of the boat with a little soapy water beforehand, as this makes it
possible to adjust the position of the decal. Once you have established the correct position, carefully
wipe the water out from under the decal; any water remaining under the decal will dissipate through
the plastic film, but this takes up to 24 hours, so do not place the boat in the water during this period.
The drawing below is intended to aid you in positioning the various decals. The stated dimensions
always refer to the outermost edge.
170
575
810
1010
1350
