GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Keine Haftung für Druckfehler. Technische Änderungen vorbehalten!
06/2007
17
Please don’t misunderstand the purpose of these notes. We only want to make
you aware of the many dangers and hazards which can arise if you work
carelessly or irresponsibly. If you take reasonable care, model flying is a highly
creative, instructive, enjoyable and relaxing pastime.
Recommended accessories
Radio control system
Min. mx-12, 35 MHz band, Order No. 4722
Receiver
smc-14, Order No. 7033
We recommend that you always use a PCM receiver.
Flight battery
LiPo 3/2000
11.1 V / 2000 mAh, Order No. 7640.3
Adhesive
Devcon 5-minute epoxy, Order No. 961.7
or comparable fast-setting epoxy resin glue
Building instructions
1)
Attach the undercarriage legs to the wing panels, as shown in the illustration.
2)
Glue the wing panels to the fuselage using Devcon or similar 5-minute epoxy. Ensure
that the wing roots line up accurately with the root fairings on the fuselage.
Use pins if necessary to hold the parts together. Wipe off excess adhesive immediately.
3)
Connect the servo extension leads. Seal the cable ducts with Tesa adhesive tape.
4)
Place the fin strake in the slot and push it up against the fin as shown.
You may need to trim the slot slightly using a sharp knife. Check that the strake is
positioned symmetrically, then glue it in place with Styrofoam cyano-acrylate (“foam
cyano”).
5)
Connect the servos to the receiver.
Install the receiver under the hatch in the fuselage; pack scrap foam round it if
necessary.
The receiver aerial must be run out of the fuselage through the hatch cover before you
fly the model.
Install the flight battery (LiPo 3/2000, Order No. 7640.3) in the battery compartment. If
you use the recommended battery, the model’s Centre of Gravity will automatically be
correct.
