12 / 16
3975_MP_V1
tion must be made. For this purpose, the ground terminals GND can
be used.
Light modules
Install your light modules in the model and connect them to one of
the three Kingbus outputs on the KBCM. On a bus it does not matter
how and where you connect which module! The extension cable is
suitable for wiring the rear lights. The system can be expanded with
the various distributors and extension cables.
First use
After everything is properly connected and wired, you can turn the
power on. The red and yellow LEDs should be constantly lit. If this is
not the case, check the wiring for any short circuits.
Adjustment and servo reverse
For the very first commissioning, you must initialize the central
module. The sticks of the remote control must be in the middle posi-
tion! Press the white Prog button for more than 2 seconds until the
yellow LED flashes once each second.
If you have a Kingpad, press each key once in a row. (See also King-
pad's manual!) As a confirmation of a recognized key, the yellow LED
remains off also if pushed. After releasing it flashes again!
After the last key, the central module automatically returns from
programming mode to normal mode.
If you do not have a Kingpad, simply press the Prog button again and
the module will return to normal mode. The zero positions for dri-
ving and steering are thus programmed.
If the drive and steering movements do not match the lighting (turn
signal and reversing light), the channels can be reversed using the
Config switches 1 and 2.
Outputs
The outputs Out1 and Out2 can be used to control additional func-
tions. The outputs switch to ground when activated.
Prog-Taster
1 Lenkkanal revers
2 Fahrkanal revers
3 Blinken bei Kurvenfahrt
4 Kurvenlicht aus
4 curve lights off
