STEP 7
Secure Blocker Plate & Attach Flap Spring
A) Drill and install six remaining tee nuts and bolts to
secure blocker plate.
B) Use a small box end wrench to hook spring over
post on hinge assembly.
C) If needed, reposition flap to make good seal. Tighten
flap mounting bolts
GrassFlap 412T Assembly Instructions
GrassFlap.com
Phone:
(502)594-3546 5
STEP 8
Install Cable
A) Slip rubber boot off fitting by pulling at base of boot.
Remove Nut 1 and slip cable wire into slot.
B) Put cable fitting into hole and snug jam nuts leaving
minimum thread showing between Nut 1 and
rubber boot.
DO NOT connect clevis to flap at this time.
DO NOT OVERTIGHTEN NUTS.
Nut 1
Boot
Nut 1
Fixed Clevis
Nut 2
