GRASS VALLEY Profile XP PVS3000, Installation Manual

Page: 24 / 46

Set up PFR600 network settings
24
PVS 3000 & 3500 Series Installation Guide 23 July 2004
Type
c
, then press Enter. (M)odify any of this or (C)ontinue? [M]
Wait for non-volatile storage
update. Updating non-volatile storage. This may take a while...Done
Wait for initialization.
NOTE: If the network cable
is not connected, the console
stops at the message
“Waiting for Ethernet
Link...”. If you cannot
connect network cabling at
this time, cycle the power on
the PFR500 Controller
chassis, then continue with
this procedure.
Initializing Enclosure Services Interface......Done
Wait for reboot, plus 10
seconds, to allow the
Enclosure Services Interface
initialization to start. Rebooting now for new system parameters to take effect
Ciprico Web Manager
Copyright Ciprico Inc. 2000
--------------------------------------------------------------------------
NETWORK INTERFACE PARAMETERS:
IP address on LAN is 192.168.0.11
LAN interface's subnet mask is 255.255.255.0
COMMUNICATION PARAMETERS:
Serial channels will use a baud rate of 9600
HARDWARE PARAMETERS:
This board's MAC Address is 0:20:46:11:15:81
APPLICATION PARAMETERS:
Boot Ciprico Network Server
Mail and SNMP notification will occur for Warnings and Critical
events.
SNMP TRAP CONFIGURATION:
TRAP COMMUNITY NAME 'public'
TRAP MANAGER #1 IP Address 192.168.0.10
After board is reset, start-up code will wait 10 seconds
--------------------------------------------------------------------------
To change any of this, press any key within 10 seconds
Instructions Text entered and displayed in terminal window
c