GRASS VALLEY Profile XP PVS3000, Installation Manual

Page: 22 / 46

Set up PFR600 network settings
22
PVS 3000 & 3500 Series Installation Guide 23 July 2004
The boot screen appears. After
default settings are displayed,
press any key within 10 sec,
otherwise, the RAID
controller will initialize and
display a command prompt.
NOTE: If you miss the 10
second window, type
reboot
again when the
command prompt appears,
then press Enter, or try
cycling the power on the
RAID Controller chassis.
You can leave the Expansion
chassis on. The boot screen
should appear.
Rebooting now - this will kill this shell.
Ciprico Web Manager
Copyright Ciprico Inc. 2000
--------------------------------------------------------------------------
NETWORK INTERFACE PARAMETERS:
IP address on LAN is 192.168.0.11
LAN interface's subnet mask is 255.255.255.0
COMMUNICATION PARAMETERS:
Serial channels will use a baud rate of 9600
HARDWARE PARAMETERS:
This board's MAC Address is 0:20:46:11:14:23
APPLICATION PARAMETERS:
Boot Ciprico Network Server
Mail and SNMP notification will occur for Hardware changes,
Warnings, and Critical events.
SNMP TRAP CONFIGURATION:
TRAP COMMUNITY NAME 'public'
TRAP MANAGER #1 IP Address 192.168.0.10
After board is reset, start-up code will wait 10 seconds
--------------------------------------------------------------------------
To change any of this, press any key within 10 seconds.
Press Enter to modify
settings. (M)odify any of this or (C)ontinue? [M]
Press Enter to configure a
LAN interface.
For each of the following questions, you can press <Return> to select
the value shown in braces, or you can enter a new value.
NETWORK INTERFACE PARAMETERS:
Do you want a LAN interface? [Y]
Type the IP address for this
RAID Controller, then press
Enter.
NOTE: RAID Controller A
and the optional RAID
Controller B must use
different IP addresses. Also,
the subnet must match the
Profile XP subnet unless a
gateway is used.
IP address(0.0.0.0 = RARP, 255.255.255.255 = DHCP/BOOTP)?
[192.168.0.11]
Type the subnet mask value,
then press Enter. Subnet mask for LAN (0 for none)? [255.255.255.0]
If a gateway is used, type
y
,
then press Enter, to provide a
Gateway address, otherwise,
just press Enter to continue.
Should there be a default gateway for packet routing? [N]
Press Enter to accept defaults.
COMMUNICATION PARAMETERS:
Baud rate for serial channels [9600]
Instructions Text entered and displayed in terminal window
<enter your IP address>
255.255.255.0