GRASS VALLEY NV9640, User Manual

Page: 82 / 112

72
Operation
Setup Mode
In this illustration, the panel ID was already set to 6412. The “Acquire IP Address” is a status
message during initialization. Until you connect the panel to its network, the status message
will remain the same.
Press the ‘Menu’ button at the far right to access the setup menu:
There are 3 setup menu choices. The ‘Exit’ button at the far right allows you to leave the menu.
•
Panel ID Entry.
Press the Panel ID Entry button to set the panel ID. A numeric button array appears:
Use the numeric button array as a keypad to enter a panel ID. What you enter appears on the
‘Panel ID’ button at the top left.
To make the ID permanent, press ‘Save’; to cancel your entry, press ‘Cancel’. In either case,
you will be returned to the setup menu.
•
Software Versions.
In the setup menu, press the ‘Software Versions’ button. Three buttons appear:
The 2 buttons at the top left display the software version numbers. Use the ‘Exit’ button on
the right to return to the setup menu.
• Panel Test Mode.
In the setup menu, press the ‘Panel Test Mode’ button. One button appears:
Press the ‘Push to Test’ button repeatedly to execute the test.
PANEL PANEL
ID ENTRY ID ENTRY
SOFTWARE SOFTWARE
VERSIONS VERSIONS
PANEL PANEL
TEST TEST
MODE MODE
EXIT EXIT
• • •
CANCEL CANCEL SAVE SAVE
PANEL ID PANEL ID
6412
6412
88 99 OO 11 22 44 55 66 77 3 3
APP APP
SVO546- SVO546-
O4 BO O4 BO
CPLD 1 CPLD 1
VERSION VERSION
O1 O1
EXIT EXIT
• • •
PUSH PUSH
TO TO
TEST TEST
• • •