74
KAM-DEC-4ADC-MUX Instruction Manual
Specifications
Specifications
Note
Specifications are subject to change without notice.
Table 6. SDI Output Specifications
Parameter
Value
SDI Output
Number of outputs
1
Signal type
Serial digital video conforming to SMPTE259M 10-bit 4:2:2 component digi-
tal signal
Signal level
800 mV ±10%
Output impedance
75
Ω
Connector type
75
Ω
BNC on rear module
DC offset
< 0.5 V when terminated into 75
Ω
Output return loss
> 15 dB up to 270 MHz
Jitter
Conforms to SMPTE17.12/002 <400 ps above 1 KHz
Rise/fall time
700 – 900 ps (20 – 80% amplitude)
SDI I/O Control Parameters
Vertical blanking processing
Line by line blank
Table 7. Composite Input Specifications
Parameter
Value
Composite Input
Signal types
Composite analog video conforming to:
NTSC (525/59.9) SMPTE170M
PAL-B/PAL-I (625/50) CCIR 624-4
PAL-M (525/59.9) CCIR 624-4 (note, PAL-M input not supported by 2000GEN)
Level
0.5 V p-p to 2 V p-p, 1 V p-p nominal
Impedance
75
Ω
terminating
Signal source
75
Ω
BNC on rear module or internal signal
Return loss
> 40 dB to 5.75 MHz
Common mode rejection ratio
> 60 dB to 60 Hz
HUM peak
< 4.5 V p-p
Composite In Performance
Sampling
27 MHz (2x oversampling)
Input quantization
12 bits
Overall processing accuracy
10 bits
Luma frequency response
± 0.1 dB to 5.5 MHz
Chroma (R-Y,B-Y) response
-1.5 dB @ 1.3 MHz
Group delay error
< 5 ns to 5.5 MHz
Chroma/luma delay
< 10 ns
Luma non-linearity
< 0.15%
K factor (2T)
< 0.5%
Line tilt
< 0.5%
