GRASS VALLEY K2 SAN, Installation And Service Manual

Page: 37 / 346

Preparing for installation
K2 SAN installation checklists
Use the following sequence of checklists to guide the overall task flow of installing and
commissioning a K2 SAN.
Pre-installation planning checklist
Comment Instructions Task
You can do this before
arriving at the customer site. About developing a system
description
on page 71
Procure existing or create new
SiteConfig system description
Next: Infrastructure checklist
Infrastructure checklist
Comment Instructions Task
— To follow cabling instructions Rack and cable
— Setting up the Ethernet switch
on page 63
Configure Ethernet switch(es)
— Install SiteConfig on control
point PC
on page 67
Install/update SiteConfig on
control point PC
Next: Network setup and implementation checklist
Network setup and implementation checklist
Comment Instructions Task
Select IP address range for
each network and each device
type. Importing a system description
on page 71
Import or create the
SiteConfig system description
on the control point PC
Set subnet mask and other
settings. Modifying a device name on
page 72, Modifying the
control network on page 72,
Modifying the FTP/streaming
network
on page 74,
Modifying a media (iSCSI)
network
on page 76
Modify names and networks
in the SiteConfig system
description.
2014 01 27 K2 SAN Installation and Service Manual 37