GRASS VALLEY K2 SAN, Installation And Service Manual

Page: 72 / 346

The current system description is closed and the system description you are importing is displayed
in SiteConfig.
About device and host names
In SiteConfig, a device can have different names, as follows:
• Device name — This is a name for display in SiteConfig only. It is stored in the SiteConfig
system description, but not written to the actual device. It is displayed in the device tree view
and in the device list view. It can be a different name than the device’s host name.
• Host name — This is the network name of the device. SiteConfig has a default naming convention
for host names which you can use or override with your own host names.
In most cases it is recommended that the Device name and Host name be the same. This avoids
confusion and aids troubleshooting.
The Device name can serve as a placeholder as a system is planned and implemented. During the
install/commission process, when you reconcile a device's current and planned network interface
settings, the Host name as configured in the system description can be overwritten by the host name
on the actual device. However, the Device name configured in the system description is not affected.
Therefore it is recommended that in the early planned stages, you configure the Device name to be
the desired name for the device, but do not yet configure the Host name. Then, after you have applied
network interface settings, you can change the Host name to be the same as the Device name. This
changes the host name on the actual device so that then all names are in sync.
SiteConfig does not allow duplicate device names or host names.
Items in the tree view are automatically sorted alphabetically, so if you change a name the item
might sort to a different position.
Modifying a device name
1. In the
Network Configuration | Devices
tree view, right-click a device and select
Rename
.
2. Type in the new name.
Note that this does not change the hostname on the physical device. If you want the hostname
to match the device name, you must also modify the hostname.
Modifying the control network
1. In the
Network Configuration | Networks
tree view, select the K2 SAN's Site node.
The networks under that node are displayed in the list view.
72 K2 SAN Installation and Service Manual 2014 01 27
Planning and implementing a K2 SAN with SiteConfig