GRASS VALLEY IQUCP25, User Manual

Page: 257 / 338

257
UCP - 3901
User Manual
Once the module has restarted, the new spigot settings are applied and spigots are set to
transmit and receive the multicast video IP streams.
STEP 3: Make a Change to the Video Wall
This sub-section uses uses the GV Orbit Client to get the video wall from a module, make a
change and push it back to the module.
Introduction
This sub-section will:
• Get the Orbit multiviewer project from the Multiviewer SDC. This is the factory default
project. See Get Orbit Multiviewer Project from the Multiviewer SDC , on page 257.
• Make a simple, visible change to the video wall. See Quick Edit of Project , on page 260.
• Push the amended project back to the unit and see the change. See Push a Project from
Orbit to a Device , on page 263.
• Pull a project from the Multiviewer SDC. See Pull a Project into Orbit from a Device , on
page 265.
Assumptions
This sub-section assumes that:
• The UCP - 3901 is connected to a media network and receiving/sending video IP
streams.
• IP addresses of the UCP - 3901’s media Ethernet interfaces are known.
• Orbit is installed on a client computer connected to the media network. (
Note:
A Orbit
license is not required for basic GV Orbit operation.)
Get Orbit Multiviewer Project from the Multiviewer SDC
To get the Multiviewer SDC’s Orbit multiviewer project:
1 Run Orbit and click File > New project .
Fig. 8-4: Orbit File > New Project