GRASS VALLEY ATP-2000, User Manual

Page: 38 / 90

17
ATP-2000
User Guide
In this way, the ATP-2000 automatically joins the GV Orbit system and is seen by all GV Orbit
Clients and appears as a device in a GV Orbit Client’s
Network window.
Accessing the ATP-2000 Control Screen
From GV Orbit Client
When DHCP is enabled on the ATP-2000 panel (default) and when the network that the GV
Orbit system uses has multicast enabled, then an ATP-2000 panel can be discovered and
appear in the
Network window of the GV Orbit Client. If the panel has not yet been set up,
then it appears in the ‘unassigned devices’ section of the Network window.
In this case, to view the control screen (web page):
1 Right-click on the ATP-2000 item in the Network window and select ‘Control’.
The unit’s control screen web page is shown. See Figure 3-3.

(See ATP-2000 Control Screen (Web Page) , on page 21 for a full description.)
Fig. 3-3: ATP-2000 Web Page
From a Web Browser
To initially display the device’s control screen (web page) without a GV Orbit system:
1 Note down the IP address of the unit, shown on its splash screen at start up (see
Figure 3-1 on page 14).
2 Enter the IP address of the unit into a web browser (for example, Chrome).
The unit’s control screen (web page) is shown. See Figure 3-3 on page 17.
Note: The ATP-2000 control screen (web page) is wide. Use pan/scroll bars
to navigate the extent of the screen, if necessary.