14
Getting Started
Start-Up Sequence
Start-Up Sequence
The panel runs through its start-up sequence when powered on. This lasts approximately 1
minute. During start-up the panel briefly displays:
1 an
; followed by
2 a
for about 1 minute; and finally
3 an operating
.
Initial Start-up Screen
The ATP-2000 initial GV Grass Valley start-up screen is shown in Chapter 2,
Splash Screen
During start-up, the panel briefly displays an initial screen followed by a
Splash
screen,
which shows some unit information, including:
• ATP-2000 panel model number.
• ATP-2000 software version.
• Unit’s IP address.
Fig. 3-1: ATP-2000 Splash Screen
Home Screen
After start-up, the ATP-2000 shows an operating
Home
screen. See Figure 3-2 for an
example home screen.
IP Address of panel
Subnet Mask
ATP-2000 product name
Software version
Note:
The operating
Home
screen shown depends on the soft panel
currently loaded into the ATP-2000 Advanced Touch Panel.
Note:
Click the
Home
icon on any screen to return to the
Home
screen.
Summary of Contents for ATP-2000
