SFP Optical Converters—Installation Manual
15
Configuration
Configuration
Once the submodules have been installed and cabled, refer to the specific
2000 and 8900 module instruction manuals for configuration and operation
information. In most cases, the fiber inputs and outputs must be enabled
using onboard local controls or through the web page GUI.
Manuals are available on-line at no cost at this link:
http://www.thomsongrassvalley.com/docs/
From this location, select
Broadcast Products
, then
Modular Products
.
Specifications
Table 1. Optical Submodule Specifications
Parameter
Value
Fiber Inputs
Connector
Up to two LC
Fiber mode
Single mode, 1310 nm nominal
Minimum input power
-20 dBm
Input signal formats
Serial digital component video conforming to the following formats:
• SMPTE 292M (1.485 Gb/s and 1.485 Gb/s/1.oo1)
• SMPTE 259M (143 Mb/s, 177 Mb/s, 270 Mb/s, 360 Mb/s)
• SMPTE 310M (MPEG to 40 Mb/s)
• SMPTE 347M (540 Mb/s)
• 4 Mbps to 1.5 Gb/s
• DVB-ASI
Fiber Outputs
Connector
Up to two LC
Fiber mode
Single mode, 1310 nm nominal
Output power
-12 to -7.5 dBm (average @ 1310 nm)
Signal type
Serial digital component video conforming to the following formats:
• SMPTE 292M (1.485 Gb/s and 1.485 Gb/s/1.oo1)
• SMPTE 259M (143 Mb/s, 177 Mb/s, 270 Mb/s, 360 Mb/s)
• SMPTE 310M (MPEG to 40 Mb/s)
• SMPTE 347M (540 Mb/s)
• 4 Mbps to 1.5 Gb/s
• DVB-ASI
