GRAPHTEC Craft ROBO CC200, User Manual

Page: 13 / 44

2-8 CHAPTER 2. CONNECTION AND PREPARATION
PREFACE PREFACE CH 1. PRIOR TO USE CH 1. PRIOR TO USE CH 3. CRAFT ROBO CONTROLLER CH 3. CRAFT ROBO CONTROLLER INDEX INDEX
CONTENTS CONTENTS CH 2. CONNECTION AND PREPARATION CH 2. CONNECTION AND PREPARATION Appendix A. Standard Specifications Appendix A. Standard Specifications
Using the carrier sheet for media from 191 to 210 mm in width (equivalent to ISO A4 size)
CHECKPOINT
Do not use media that is wider than 210 mm with the carrier sheet.
(1) Peel off the inside liner and the liner strips on both sides of the carrier sheet, so that the entire
adhesive surface is visible.
Liner
Peel off the inside liner and the liner strips
on both sides of the carrier sheet.
(2) Press the media onto the adhesive surface of the carrier sheet.
CHECKPOINT
• When pressing the media onto the adhesive surface, be careful not to cause air
bubbles or wrinkles in the media.
• Make sure that all of the media is pressed down.
• Make sure that the edges of the media are parallel to the edges of the carrier sheet.
Adhesive surface
Media
Carrier sheet