Graphite 58G111, Instruction Manual

Page: 14 / 36

14
●
Green diode on – indicates voltage on the connector.
R
ed diode on
●
– battery charging in progress.
R
ed diode turns of
●
– battery is fully charged (after 5 hours) or battery temperature is too high (above
45 0 C).
E
ach time the battery is removed and inserted into a charging station during a recharge, the charging
cycle resets and another
5
hours cycle is started regardless of the current battery capacity.
When the battery temperature rises too much during a recharge (above 4
5
°C) and recharge is
stopped (red diode goes of), remove the battery from charging station, wait approximately for
3
0
minutes and put the battery back in the charging station.
S
uch temperature rise inside the battery
is not likely and may never occur.
Charging process heats up the batteries. Do not work just after charging is inished - wait until
battery cooles down to ambient temperature, otherwise the battery will be damaged.
SP
INDL
E
B
R
AK
E
Drill driver is equipped with electronic brake, which stops the spindle immediately after the switch button
(
6
) is released. The brake ensures precision when screwing or drilling and prevents free spindle rotation
after it is switched of.
OPERATION / SETTINGS
S
WI
T
CHING
O
N /
S
WI
T
CHING
O
FF
S
witching on – press the switch button ( 6 ).
S
witching of – release the switch button ( 6 ).
Each time the switch button (
6
) is pressed, the LED diode (
8
) lights up to illuminate the workplace.
ROT
A
T
I
O
NAL
SPEE
D C
O
N
TRO
L
Screwing or drilling speed can be controlled during operation by increasing or decreasing pressure on the switch
button (
6
). Speed control enables soft start, which prevents drill slip when drilling in gypsum or glaze, and
helps to control the operation when screwing and unscrewing.
O
V
ER
L
O
AD CLU
T
CH
Setting the ring (
2
) in given position causes permanent setting of the clutch to speciied torque. When
the set torque is reached, overload clutch releases automatically.
I
t prevents screwing screws too deep or
damaging the drill.
TOR
QU
E
C
O
N
TRO
L
●
Diferent screws and materials require diferent torque to be applied.
The bigger the number corresponding to given position, the bigger the torque (
●
ig. D ).
Set the ring (
●
2
) to speciied torque.
Always start operation with low torque.
●
I
ncrease the torque gradually until appropriate value is set.
●
Use higher settings to unscrew screws.
●
When drilling choose settings marked with the drill symbol. When this setting is set, the torque is the
●
greatest.
Knowledge how to choose appropriate settings comes with practise.
●
S
etting the ring in the drilling position deactivates the overload clutch.
W
OR
KING
TOO
L IN
ST
ALLA
T
I
O
N
●
Set the direction selector switch (
3
) in the middle position.
H
old the rear ring of the quick release chuck (
●
1
) and turn front ring counter-clockwise to open jaws
appropriately and insert drill or driver bit ( ig.
E
).
H
old the rear ring of the quick release chuck (
●
1
), turn front ring clockwise and tighten irmly to install
working tool.