- 7 -
7
4
6
5
2
3
1
1.
USB
2.
Centronics
3.
RS-232
4.
Power Switch
5.
Power Cable
6.
Power Supply
7.
Plug
2.
CONNECT PRINTER
**IMPORTANT**
These Steps need to be done in the order below!
1.
Connect the
power supply
.
2.
Connect the DuraLabel PRO 300 to your PC using the
USB or parallel
cable
.
3.
Turn on the
DuraLabel PRO 300.
(Switch is in back of printer,
See Figure 6
)
3.
INSTALL USING USB CABLE
**IMPORTANT**
You must have administrative rights in order to perform this installation.
1.
A “Found New Hardware” dialog box may appear. If so, select “
No, at this
time
.”
2.
Insert DuraLabel PRO 300 Installation CD into the CD-ROM drive.
3.
Select “
Install the software automatically
” and click “
Next
.”
(Step 3 of "Install Using USB Cable" may run automatically.)
4.
When prompted to continue, click “
Continue Anyway
.”
5.
A dialog will appear showing the installation progress and will close after
completion.
6.
A Found New Hardware dialog box will appear, click “
Finish
” to exit and to
close the window.
7.
Skip to page 9, Step “5. Set up to Print.”
Figure 6
