Rotate the knob so that [
]is displayed, press
and another
segment [ ] will be displayed,
Rotate the knob so that [
] is displayed and press
to adjust. Adjust to 40°C
then press
to accept.
Rotate so that [
] is displayed and press the
button to adjust to 20 minutes.
As we are still working at elevated temperatures we do not require the refrigeration.
Rotate the knob so that [
] is displayed, by pressing the
button, activate relay
[ ].
You have now finished programming. Press
(cancel ) four times to bring you back to
the display with [
] and [
] on it. When the program has finished the
thermostat unit will revert back to the
temperature. To adjust this press
and
adjust the temperature with the knob, then press
again.
You can now run the program. Press
and rotate the knob until [
] is
displayed. Press
to select [
] and
again to start the program.
If the thermal ramping as described in example 1 is to be carried out with a GR150
thermostat, then Labwise software is required. Refer to Labwise Programming
instructions (Grant Part No. 17093.0
Phase 4
Requirement:
3InsertAfter
4
4.Temp
4Tim
4.Relays
1
Int. Temp
SetPoint
Programs
Program 1
S
F
Set Point
S
4.3
Example 3 - GR150/(R2/R2L, R3/R3L, R4/R4L, R5)
e
introducing Phase 4.
S
S
S
S
S
S
F
S
)
Page 14
Low temperature bath/circulator
Operating instructions
Version 4 - Jan 2010
