O
perating Instructions for Digital Fence Tester
580580479
4
If during operation (residual) hazards and risks become apparent which are not described
in this manual, the operator is obliged to report this to the manufacturer.
2.2
Specific safety instructions
The equipment may only be used by trained persons. Observe the regulations of the
employer’s liability insurance association for health and safety at work for all activities.
To prevent electric shock, the precautionary measures must be observed when working
with voltages higher than 35 V DC or 16 V rms. AC. According to DIN VDE, these values
represent the limit of the voltages that can still be touched. The values are valid for
agricultural applications.
The equipment may only be touched at the designated handling areas, and the display
elements may not be covered.
Maintenance work that is not described in this documentation may only be carried out by
trained service technicians.
If the equipment is modified or altered, its operational safety is no longer guaranteed.
The earth spike must not be used with the battery compartment open.
When inserting the earth spike, do not touch any live parts.
Check the batteries before use and replace them if necessary.
If batteries are leaking, stop using the equipment until it has been checked by our
customer service.
The battery liquid (electrolyte) is strongly alkaline and electrically conductive. Risk of
burns! If battery fluid comes into contact with skin or clothing, the affected areas must be
rinsed thoroughly with plenty of water immediately. If battery fluid gets into the eyes,
rinse them immediately with plenty of water and consult a doctor.
Do not operate the equipment in rooms where there is a risk of explosion.
Do not operate the equipment in an aggressive atmosphere.
Protect the equipment from permanent direct sunlight.
The equipment is used only to indicate the voltage range and is not suitable for
measurement purposes.
Test the functionality of the voltage tester immediately before and after each use. The
voltage tester must not be used if the function of one or more displays on the voltage
tester fails or if the functionality of the equipment cannot be clearly determined.
Failure to observe the following safety instructions can lead to serious
accidents with severe material damage and personal injury!
