GPCP-E is combined by GPCP and GPE
Firstly, collect the power wires to the main bar as figure 1.
Invaginate the low cap to the main bar as figure 2. Install the
low board to the main bar, and then fasten the screws
(accessories 5 ) as figure 3. Finally, install the front board to
installation board of main bar and install the adjuster to the
front board, and then fasten the screws (accessories 6) as
figure 4.
1
2
1-1
1-3
1-4
2-2
1-2
2-1
2-3
GPCP Main Bar Overview
1-1 Top Cap
1-2 Front Board
1-3 Subsidiary Bar
1-4 Main Bar
1-5 Installation Board
2-1 Low Cap
2-2 Low Board
2-3 Fixation
GPD Adjustment Overview
3-1 Adjuster
3-2 Horizontal Adjusting
Button
3-3 Vertical Adjusting
Button
4-1 Installation Bracket
4-2 Rotation Adjusting Screw
4-3 Installation Arm
4-4 Adjustable screw
4-5 Sliding Installation
Button
4-6 Installation Base
1-5
accessory 5
Parts
Scope for installation (Installation hole of projector):
Maximum scope for installation:390mm diameter
Minimum scope for installation:20mm diameter
Note: Connect the installation arms to the projector conversely for different installation
holes of projector.
Maximum diameter: 390mm
Scope
Minimum diameter: 20mm
Scope for installation (H is the distance between ceiling and projector)
The H of GPCP-E4060 is 420mm~600mm
The H of GPCP-E6090 is 600mm~900mm
The H of GPCP-E90150 is 900mm~1500mm
Scope
Steps of installation
figure 1
figure 2
figure 3
figure 4
Install the fixation on the wall (choose the screws according
to the materials of wall, Use the screw of accessory 7 for
concrete-wall, and use the screw of acessory 8 for wood-
wall) as figure 5.And then, install the Main Bar Overview to
the fixation and fasten the screws (accessory 5). Finally,
connect the GPE Adjusting Overview to the adjuster and
then fasten the screws (accessory 6 ) as figure 7.
Steps of installation
figure 5
figure 7
figure 6
Details of installation
Wires collection
Loosen out the positioning screws of main bar (1-4) as figure 8, and then
take apart subsidiary bar (1-3) from main bar (1-4). Put the wires into
the main bar (1-4) then insert the wires to the plastic groove of
subsidiary bar (1-3). And then, re-install the subsidiary bar (1-3) to main
bar (1-4) after collecting the wires as figure 9-10.
figure 8
figure 9
figure 10
①M3X8 Philips Screw (4pcs)
②M4X8 Philips Screw (4pcs)
③M5X8 Philips Screw (4pcs)
④M5X8 Philips Screw (4pcs)
⑤M6X12 Anti-Slip Screw (2pcs)
⑥M5X10 Philips Screw (7pcs)
⑦M6X25 Tapping Screw (4sets)
⑧ 6X50 Wood Screwn (4sets)
Accessories
3-1
3-2
3-3
4-1
4-5
4-2
4-4
4-3
4-6
H
GPCP-E
