5
8
图
6
CONTROLLER
G1
up
Dry
contact
CAT6
CAT6
RS-485
IN-
220V 50Hz
INPUT
HDMI2
.
0
stopdown
Rotate left and right ±3°
1° vertically upwards and 8° vertically downwards
Adjust the length of the mounting feet
figure
1
figure
2
figure
3
1
.
Rotate left and right
Use a hex wrench to loosen the two screws on the front end.
As shown by the arrow in Figure 1, the universal joint can be
adjusted to the left and right by ±3°.
2
.
。
vertical up and down adjustment
As shown in Figure 2, use the hex wrench to loosen the two
screws on the left and right. The universal joint can be adjusted
vertically upward by 1° and vertically downward by 8°.
3
.
The installation foot adjustment
Use a hex wrench to loosen the screws on the mounting feet.
As shown in Figure 3, adjust the screws to the desired length
and retighten the screws.
Angle adjustment
Electrical, product instructions
Concrete base
2
.
Punch the concrete base and install the Tapping screws.
Installation steps
1
.
determine the direction of the projector and the installation position, according to the size
of the opening in the ceiling layer.
Concrete base
Ceiling decorative layer
(Ceiling opening size diagram)
Projection direction
980mm
1310mm
615mm
1260mm
Projection direction
T
apping sc
rews
Control panel description:
UP : projector lift up
STOP: projector lift stop
DOWN : projector lift down
Communication port: Category 6 network port
Dry contact: dry contact interface
RS485: RS485 interface
Power input: power input interface
Reset: long press the UP button, the lift is reset
HDMI 2.0: 19+1 2.0 HD interface
Summary of Contents for GPAC76Series
Page 2: ......
