Grandstream Networks Multiple UCM6510 IPPBX How To Interconnect Download Page 2

Page: 2 / 9

How To Interconnect Multiple UCM6510 IPPBX Page 1 of 8

Index

Table of Contents

OVERVIEW ................................................................................................ 2

CONNECT TWO UCM6510 USING PEER SIP TRUNK ............................. 3

CREATE PEER SIP TRUNK FOR UCM6510 ........................................................................................ 3

CONFIGURE OUTBOUND RULE ON UCM6510 ................................................................................. 5

CONFIGURE INBOUND RULE ON UCM6510 ..................................................................................... 7

Table of Figures

Figure 1: SIP Trunk - Create New SIP Trunk ................................................................................................ 3

Figure 2: SIP Trunk - Set Enable Qualify ...................................................................................................... 4

Figure 3: SIP Trunk - Trunk Status ................................................................................................................ 4

Figure 4: Outbound Rule - Create New Outbound Rule ............................................................................... 6

Figure 5: Inbound Rule - Create New Inbound Rule ..................................................................................... 7

This document is subject to change without notice. The latest electronic version of this document is

available for download here:

http://www.grandstream.com/support

Reproduction or transmittal of the entire or any part, in any form or by any means, electronic or print, for

any purpose without the express written permission of Grandstream Networks, Inc. is not permitted.

Summary of Contents for Multiple UCM6510 IPPBX









