P a g e
|
31
GXP17xx Administration Guide
Refer-To Use Target
Contact
If set to "Yes", the "Refer-To" header uses the transferred target's Contact
header information for attended transfer. The default setting is "No".
Transfer on
Conference Hang-
up
If set to "Yes", when the phone hangs up as the conference initiator, the
conference call will be transferred to the other parties so that other parties will
remain in the conference call. The default setting is "No".
Disable Recovery
on Blind Transfer
Disable recovery to the call to the transferee on failing blind transfer to the
target. The default setting is “No”.
No Key Entry
Timeout (s)
Defines the timeout (in seconds) for no key entry. If no key is pressed after the
timeout, the digits will be sent out. The default value is 4 seconds. The valid
range is from 1 to 15.
Use # as Dial Key
Allows users to configure the "#" key as the "Send" key. If set to "Yes", the "#"
key will immediately dial out the input digits. In this case, this key is essentially
equivalent to the "Send" key. If set to "No", the "#" key is included as part of the
dialing string and please make sure the dial plan is properly configured to allow
dialing # out. The default setting is “Yes”.
Account x
Feature Codes
Enable Local Call
Features
When enabled, Do Not Disturb, Call Forwarding and other call features can be
used via the local feature codes on the phone. Otherwise, the provisioned
feature codes from the server will be used. User configured feature codes will
be used only if server provisioned feature codes are not provided. And once
feature codes are configured, either via server provisioning or local setting, a
softkey named “Features” will show on the LCD screen.
Do Not Disturb
(DND)--On
Configures DND feature code to turn on DND.
Do Not Disturb
(DND)--Off
Configures DND feature code to turn off DND.
Delayed Call
Forward Wait Time
Defines the timeout (in seconds) before the call is forwarded on no answer. The
default value is 20 seconds. The valid range is 1 to 120.
Settings Page Definitions
Table 7: Settings Page Definitions
Settings
General Settings
Local RTP Port
This parameter defines the local RTP port used to listen and transmit. It is the
base RTP port for channel 0. When configured, channel 0 will use this port _value
for RTP, channel 1 will use por2 for RTP. Local RTP port ranges from
1024 to 65400 and must be even. The default value is 5004.
Use Random Port
Forces random generation of both the local SIP and RTP ports. This is usually
necessary when multiple phones are behind the same full cone NAT. The default
setting is "Yes".
