GVR3550 USER MANUAL
Grandstream Networks, Inc.
GVR3550 User Manual
Page
30 of 76
Firmware Version 1.0.0.0
Last Updated: 10/2013
PRESET
Users could choose PTZ control as preset then make operations like add/delete/edit preset on the control
panel below. The procedures are shown in figure 19.
Figure 19:
GVR3550 PTZ Control Page---Preset
1.
Adjust the remote camera position via the PTZ direction control.
2.
Click on
below the preset control panel to add a new preset.
3.
Enter the name of preset in the added input box or use the default name.
4.
Click the check button on the right to save the preset, or click
on the right of the preset to edit the
name.
5.
Double click the preset with mouse(or the Confirm button on the front panel , or the Enter button on the
control) to activate it.
6.
Once selected the preset, users could click on the button
below the preset control panel to cancel the
operation if don
’
t need it.
PATROL(TBD)
Users could edit and apply patrols on the control panel if set PTZ operation to patrol. The factory default
setting are 4 empty patrol paths. See figure 20.
Figure 20:
GVR3550 PTZ Control Page---Patrol
1.
Set PTZ control to patrol.
2.
Select the patrol path.
3.
Set the time duration the patrol path stays at each preset .
4.
Click on
to add key point and set it as one preset. Users could click on
in the lower right corner of
the panel to delete the key point if set the wrong key point.
5.
Click on
before the patrol path. Once the button turns into a triangle
, the PTZ will cycle according to the
path. Click
again to stop the patrol.
CONTRAIL(TBD)
Users could edit and apply contrail on the control panel below if set PTZ operation to contrail. The factory
default setting are 3 empty contrails. See figure 21.