Grandstream Networks, Inc.
DP715-US/DP710-US User Manual
Page
33 of 43
Firmware 0.0.0.8
Last Updated: 03/2012
Lock Keypad Update
Default is
No
. If set to “Yes”, the configuration update via keypad is disabled.
Disable Voice Prompt
Default is
No
. Disables the voice prompt configuration.
Disable Direct IP Call
Default is
No
. Disables the Direct IP Call function.
Failover to FXO
Gateway
Default is
Disable.
If Enabled, the unit will start routing the calls to the FXO Gateway
configured via Direct IP Call When it loses registration from your SIP Server.
The use of this option presumes a configured GXW410x or another FXO gateway with an
active PSTN line connection.
FXO Gateway
IP or Domain Name of the FXO Gateway that will be used as Failover.
NTP server
URI or IP address of the NTP (Network Time Protocol) server. This parameter
synchronizes the date and time.
Allow DHCP option 42
to override NTP serve
Default
NO.
Enables the DHCP server to handle the NTP Server via Option 42
Syslog Server
The IP address or URL of System log server. This feature is especially useful for the ITSP
(Internet Telephone Service Provider)
Syslog Level
Select the DP715 to report the log level. Default is NONE. The level is one of DEBUG,
INFO, WARNING or ERROR. Syslog messages are sent based on the following events:
1.
product model/version on boot up (INFO level)
2.
NAT related info (INFO level)
3.
sent or received SIP message (DEBUG level)
4.
SIP message summary (INFO level)
5.
inbound and outbound calls (INFO level)
6.
registration status change (INFO level)
7.
negotiated codec (INFO level)
8.
Ethernet link up (INFO level)
9.
SLIC chip exception (WARNING and ERROR levels)
10.
memory exception (ERROR level)
The Syslog uses USER facility. In addition to standard Syslog payload, it contains the
following components:
GS_LOG: [device MAC address][error code] error message
Example
: May 19 02:40:38 192.168.1.14 GS_LOG: [00:0b:82:00:a1:be][000] Ethernet link
is up
Send SIP Log
Default is
No.
If Enabled, the DP715 will send a replicate of the SIP packets on the
syslog.
Primary RADIUS
Server
Set the IP or FQDN of the Primary RADIUS Server.
Remote Authentication Dial In User Service (RADIUS). DP715 supports RADIUS for
authentication, authorization and billing purposes. Primary and secondary RADIUS server
configurations are available to provide redundancy to this feature. In case Primary Radius
server becomes unusable, RADIUS requests will be automatically sent to the secondary
server. When at least one RADUIS server was configured, the device will allow users to
make phone calls only after authorization from RADIUS server has been received. CDR
(Call Detail Record) is also sent to the RADIUS server for billing purposes. RAIDUS
server can send requests to terminate calls when run out of pre-paid credit.
Primary RADIUS Auth
Port
Default is
1812.
Specifies the port to be used for the Primary RADIUS Authentication.
