GRANDSTATE 11111411 E, Safety, Installation, Operation And Maintenance, Page: 15 / 52

15
For your safety
Do not store or use gasoline or mentholated fuels or any other flammable vapors and liquids
in the vicinity of this or any other appliance. Never light a gas grill with gasoline or comparable fluids!
Suggestion: user should not change the assembly that the manufacturer packaged.
General
Although all gas connections on the grill are leak tested at the factory prior to shipment, a complete gas
tightness check must be performed at the installation site due to possible mishandling in shipment, or excessive
pressure unknowingly being applied to the unit. Periodically check the whole system for leaks following the
procedures listed below. If the smell of gas is detected at any time you should immediately check the entire
system for leaks.
Before testing
Make sure that all packing material is removed from the grill including tie-down straps.
Before using the grill, you will want to light it and allow it to “burn-in” for 15 to 20 minutes on the highest level.
This one-time procedure may cause a slight smoke emission.
Strongly recommended procedures/usage
When using the gas cylinder, it must always be kept in upright position.
This appliance must only be used with an approved hose and regulator.
A gas cylinder of max. 11 kg may be placed in the grill cabinet during use.
Place the gas cylinder upright in the cylinder bracket and secure it with the
safety belt to prevent it from falling over.
Preparation
You will need to purchase a gas cylinder and the pressure regulator should correspond to the pressure and
gas category of the appliance, which can be obtained from your nearest gas retailer. The regulator should be
complying with EN16129 with current version and national regulation. You will need to purchase a gas cylinder
and a 28-30/37 mbar regulator for I3+(28-30/37), 29 mbar regulator for I3B/P(30), 37 mbar regulator for I3B/P(37)
and 50 mbar regulator for I3B/P(50) to operate this gas grill which can be obtained from your nearest gas retailer.
If the hose and regulator are not included by the manufacturer, then only hoses and regulators which meet
national and regional codes are to be used. Connect the hose and regulator to the gas cylinder at the left side
of the gas grill. Keeping in mind that the gas cylinder must be kept away from heat and in a safe position.
Warnings
Before attempting to light your gas grill you must refer to your lighting instructions and warning/safety points.
Check the hose before each use, searching for cracking, cuts or any abrasions. If the hose is found to be faulty
in any way do not attempt to use your gas grill.
When changing your gas cylinder ensures that there are no sources of ignition close by i.e. fires, cigarettes,
naked flames etc. Make sure that the appliance is switched off.
Ensure that the hose is not subjected to twisting which will affect the gas flow when using your gas grill.
Also the hose must not have undue tension and must not touch any part of the gas grill which may be hot.
Please choose flexible hose whose heatproof higher than 80 °C.
Every 2 years changing the flexible hose when the national conditions require it.