Page 3
Q
Q
F
N
N
H
Place the completed seat assembly over the glider base assembly. Use 1/4"x65 mm bolts (F) to attach back portion of seat assembly to rear glider
bracket on glider base. From the outside of the glider bracket, insert bolt (F) inward in this exact order through: glider bracket / Ø15x6 mm washer (N)
/ glider seat frame (E) / Ø15x4 mm washer (M) / Ø6.5x1.0mm washer (K) / 1/4" nut (O) as shown in
.
Use 1/4"x45mm
bolts (H) to attach front portion of seat assembly to front glider bracket on glider base. From the outside of the glider bracket, insert bolt (H) inward in
this exact order through: glider bracket / Ø15x6 mm washer (N) / glider seat frame (E) / Ø15x4 mm washer (M) / 6.5x1.0 mm washer (K) / 1/4" nut (O)
as shown in
Repeat entire
on opposite side.
Using hex wrench and hex bolt driver provided, tighten all nuts and bolts a few revolutions at a time, alternating between glider bracket connections
until all nuts and bolts are completely tight.
Test of operation of glider. Gliding motion should be smooth. Adjust tension on
the glider brackets, nuts and bolts as needed. If nuts and bolts are either too tight or too loose, the glider will not function properly.
Cover all nuts and bolts with covers provided. Your glider is now ready for use.
Step 4:
Do not over tighten.
Do not over tighten.
Step 4
Step 5:
Do not over tighten.
1-800-491-4958
Fig.4
Fig.5
IMPORTANT NOTE: Damage to welds or frames resulting from over tightened bolts or improper assembly is not covered under our warranty.
Please read all instructions carefully before assembly. If you have any questions regarding your assembly, call our Product Specialists at
.
Fig.4
Fig.5
M
O
K
M
O
K
