WUXI CHARTER MACHINERY MANUFACTURE CO., LTD
LIGHT THE GRILL:
Always keep your face and the body as far away from the grill as possible when lighting.
Open the grill lid before lighting. Failure to open grill lid during the lighting procedures could
result in a fire or explosion that could cause serious bodily injury, death, or property damage.
Insert match or lighter through access hole next to the burner tube. Keep flame next to burner
while pushing and turning the control knob to the “HI” position on regulator.
If the burner does not light in 4 seconds, turn knob to “OFF” and wait 5 minutes before re-
lighting, to allow any accumulated gas to dissipate. If the burner will not light after several attempts,
then it can be match lit.
Keep your face as far away from the grill as possible and pass a lit, long stem match through the
grilling grid to the burner.
Position the match near the burner ports. Push and turn the control knob to “HI”.
If the burner does not light in 4 seconds turn the knob to “OFF”, wait 5 minutes and re-lighting.
OPERATE GRILL BETWEEN “HI” AND “LO” SETTING ONLY. OPERATING GRILL BELOW THE “LO” SETTING CAN
RESULT IN A DANGEROUS FLAME-OUT AND BUILD-UP OF GAS. IF FLAME-OUT OCCURS, TURN KNOB TO “OFF” FOR
FIVE MINUTES BEFORE RE-LIGHTING.
IMPORTANT:
DO NOT LEAVE THE GRILL UNATTENDED AT ANY TIME WHILE THE GRILL IS IN USE.
DO NOT KEEP USING THE BARBECUE BEYOND 20 MINUTES AT HI POSITION WHEN THE LID IS CLOSED DURING
COOKING. THIS MAY OVERHEAT THE BARBECUE, CAUSING DAMAGE TO THE BARBECUE AND HOOD.
TURN OFF
After cooking, turn the grill off by rotating the control knob to OFF. Control knob should pop up in the
OFF position. If control knob does not pop up, disconnect cylinder to turn the grill off and replace the
regulator.
Allow grill to cool completely before handling.
STORAGE
Make sure the grill has completely cooled. Remove propane cylinder and replace plastic cap on cylinder.
Remove regulator from the grill to help keep dirt out of the propane cylinder probe. To protect the regulator
during storage and transport, the regulator has been designed to be easily installed or removed from the grill.
Before use, screw the regulator assembly into the plate on the side of the grill. Tighten by hand only – no tool
required. When finished grilling, allowing the grill to cool, then disconnect propane cylinder from the regulator,
and unscrew regulator assembly from grill. Store regulator in a heavy plastic bag and place inside grill.
WARNING