Grand Design Reflection Fifth Wheel 150 Series, Owner'S Manual

Page: 170 / 220

Slideout Systems
164
Lippert Electric Slideout System, Continued
• When operating the Lippert electric slideout system in
harsh environments (i.e., road salt, ice buildup, etc.)
keep all moving parts clean, washing them as needed,
with mild soap and water.
• Grease or lubrication is NOT necessary. It could even
harm the long-term dependability of the slideout system.
Service and adjustments
• Slideout room adjustments should be performed
ANNUALLY by a certified RV service technician.
• Any adjustments made by non-certified persons
may void any and all warranty claims.
Schwintek In-Wall Slideout System
Typical IN-WALL slide controller is located in the front facing
compartment of your FW. See Photo , On Facing Page.
If the bedroom IN-WALL slideout does not extend or retract,
follow these steps to override the system (it will be easier if
you have one or more persons to assist you):
Electronic manual override
for board revision C1 and newer:
1. The Schwintek circuit board for each slideout is located
in the Front Compartment.
2. PRESS the MODE button six (6) times quickly, then
PRESS a seventh (7th) time and HOLD for approximately
five (5) seconds.
3. The RED and GREEN LED lights will begin to flash,
confirming the override mode.
4. Release the MODE button.
5. Back inside the RV, PRESS and HOLD the Slide Room 2
switch IN until the room retracts completely.
During this override
procedure, the Schwintek
slide room motors are not
synchronized. Visually
watch the slide room,
and if one side is moving
significantly slower than
the other (or not at all),
immediately stop and call
your dealer or Grand Design
RV Customer Service.
CAUTION