11
When you press the power key, the display lights up and goes through the
following sequence
1.
On the LCD display all the segments and symbols light up for one
second to check that they are working correctly.
2.
Then the version code of the equipment firmware is shown for
one second.
3.
Finally, the maximum capacity and resolution of the scale are
displayed for one second.
While the indicator establishes the connection with the forks, the LCD display
shows "
oooo
".
Once the connection with the forks is established, the display will indicate
the weight.
If no change in weight is detected, after 5" the display turns off and the
system goes to standby (low power) until a new load is detected in any of the
forks.
In idle condition, the LCD display indicates the remaining autonomy of the
equipment by means of a percentage:
B 100
