25
Auto simple calibration
Press
key for about 3 seconds and the display will show a “calibration
weight value”.
Put the weight exactly the same with the display value on the pan. When the
“CAL” flashing at the lower right disappears, the Calibration procedure is
finished.
Recovery of the default values from memory
In normal weighing mode, hold down the
F
key for 3 seconds. Then the
balance will be recovered with a default calibration values.
SPECIfICATION Of OUTPUT INTERfACE
Mode: EIA-RS-232 C’s UART signal, or USB signal
format:
baud rate:
1200-9600 BPS
Data bits:
8 bits/ 7 bits
Parity bit: none/Even
Stop bit:
1 bit
Code:
ACSII
RS232 connector is a 9-pin D-subminiature socket.