temperature is 1 degree lower and 2
degrees higher than the set
temperature in order to keep the
space warm enough. The heater will
turn OFF when the room temperature
is 3 degrees higher than the set
temperature, and will start
automatically when the room
temperature drops below 2 degrees
than the set temperature.
For example: If your ideal setting is
72
°
F, the heater will keep LOW
heating output in 71F to 74
°
F, and will
turn OFF at 75
°
F.
The default temperature setting is
preset from the factory at 70 degrees
Fahrenheit.
6. For more efficient heating, please
try placing the heater a few feet
above the floor in rooms with large
area. Make sure the heater is secure
and won't fall.
Remote Controller
HOW TO INSERT BATTERIES
NOTE
: Remove the batteries if the
remote control is not to be used for a
month or more. Batteries left in the
unit may leak and cause damage.
“ DO NOT MIX OLD AND NEW
BATTERIES”
“ DO NOT MIX ALKALINE,
STANDARD (CARBON-ZINC) OR
RECHARGEABLE
(NICKEL-CADMIUM) BATTERIES.
Instructions for use of IR
Remote Control
:
The buttons of the remote control will
function in the same manner as the
buttons on the control panel in front of
the heater, you can set the timer by
using the remote control:
To set the timer
1. Press the TIMER button until the
Set Time starts flashing. The
default value is 3 hours.
2. Press the “+” button to increase the
set time or the “–“ button to
decrease the set time.
The timer can be set from 1 hour to 12
hours. The timer will set and execute
after the LED display stops flashing.
The heater will shut OFF
automatically when the set time is
reached.
3. To turn the timer OFF, follow step 1
and press the “–“ button to set the
time to 0. The timer feature will turn
off when the LED stops flashing
Maintenance
1. Always turn OFF the heater and
disconnect the cord from the
electrical outlet before cleaning
your heater.
2. Light accumulated dust may be
removed from the heater with a
soft cloth or vacuum cleaner.
3. Wipe the exterior surfaces of the
heater occasionally with a damp
cloth (not dripping wet), using a
solution of mild detergent and
water. Dry the case thoroughly
before operating the heater.
Caution: Do not allow water to run
into the interior of the heater
as this could create a fire or
electric shock hazard.
