19.
CHECK YOUR HEATER CORD
AND PLUG CONNECTIONS.
Faulty wall outlet connections or
loose plugs can cause the outlets
or plug to overheat. During use,
please check frequently to
determine if your plug outlet or
faceplate is HOT! If so,
discontinue using the heater
and/or have a qualified electrician
to check and replace the faulty
outlet(s).
CAUTION: This appliance is not intended
for use by persons (including children)
with reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning use
of the appliance by a person responsible
for their safety
SAVE THESE
INSTRUCTIONS
Operating Instructions
.
1. Plug the power supply cord into a
grounded wall outlet. (110/120VAC,
60Hz)..
Important
:
This heater comes with a
grounded (3 prong) plug. The
grounded plug must be used with a
grounded outlet. Do not use an
adapter in a 2-slot wall outlet unless
the ground plug of the adapter
properly connects to a building ground.
Using heater without properly
grounded outlet or adapter could
result in an electric shock hazard.
2.
TURNING THE HEATER ON:
To turn the heater ON, press the
power button, the power LED light
will turn on. Pressing the MODE
button will allow you to set the heat
settings: press once to set to
AUTO, press twice to set to HIGH,
press three times to set to LOW
and press a fourth time to turn the
heater OFF.
3.
TURNING THE HEATER TO
STANDBY:
To turn the heater to
STANDBY, press the STANDBY
button. The heater will shut off but
the fan will continue to run until all
the heat has been expelled. The
heater will turn off automatically
and is set to standby mode. If you
are not going to use the heater for
a long time. Press Power button to
fully shut down the heater. The
power LED will turn off.
4.
SETTING THE THERMOSTAT
Press the MODE button, set to
AUTO mode to engage the
automatic thermostat.
5.
SETTING THE TEMPERATURE
To set the desired temperature:
Press the button once until
the numeric temperature starts
flashing.
Press the button again to
increase the temperature or the
button to decrease the
temperature.
The desired temperature will set and
execute after the LED display stops
flashing and displays the room
temperature again. This is your ideal
setting. The heater will keep LOW
heating output when room
