INSTALL THE DUAL VALVE TAP
1. Unpack the fermenter and all its parts. Remove
all the protective packaging and then assemble
the dual valve tap.
2. Attach the valve to the bottom of the fermenter
by inserting the cone plug seal. Then use the tri
clamp to tighten it and secure it in place.
4. Then plug the other end of this cord, into the
power adapter. Do not plug this into a wall and
switch on the power until you are ready to heat
the fermenter.
ATTACH THE BUNG, AIRLOCK AND LID
5. Push the rubber bung into the hole in the
fermenter lid. Once fitted, push the airlock into
the hole of the rubber bung. The airlock stops
anything from entering the fermenter during
fermentation, helping to keep your brew safe.
NOTE: Clean the unit as per the cleaning
instructions before use.
SCREW
ON BALL
VALVE
ATTACH
LIQUID
INLET
ASSEMBLY
4
CONNECT THE POWER CORD
3. Plug the 2 m (6.6 ft) power cord into the back of
the fermenter.
