10
Configure Output Bus Assignment
Configure Bus Assignment
The D/ESAM 8000 operates with a familiar video switcher-style
interface whereby sources are placed on Program and/or Preset buses.
When a transition is initiated, either manually with the Trans Start
button on the control panel or via an edit controller, the D/ESAM 8000
will transition from the source on the Program bus to the source on the
Preview bus.
Bus assignment is the way to take channel 2 of your source and have
it go out to channel 1 of the master, for example. The D/ESAM 8000
offers you an easy method for adjusting the output bus assignment of
logical machines.
Manual Operation
In manual operation, you can simply press the desired output bus
button (labeled 1-8 vertically above the faders) and adjust the faders
to the desired level to configure your source.
Follow the steps below to manually configure the output bus
assignment:
1.
Press , or both buttons on the control panel to select
which output bus you are configuring.
2.
Simply toggle on or off the output bus buttons for the desired
source. These are labeled 1-8 vertically above the faders.
Additionally, you can set the output level by adjusting the faders
for the desired source.
Editor Control
Under editor control, whenever you select the source on the editor, the
default output bus assignment will be selected on the mixer. If you do
not want the default configuration then you must configure the bus
assignment.
Summary of Contents for D/ESAM 8000
Page 1: ...D ESAM 8000 QuickStart Guide Revision 1 6 January 2002...
Page 22: ......
